Tool And Die Maker  

Personnel Plus, Inc. - Twin Falls

Personnel Plus of Twin Falls is hiring for a Tool and Die Maker Temp to Hire position Full time 40+ hours $24-$26 Duties: include but not limited to Exhibit excellent troubleshooting skills. Build and understand engineering of all new dies: Progressive, Draw, CI, etc. Set-up and operate tool room equipment with minimal or no supervision. Work cohesively with production department and die ship personnel. Able to work independently on most repair work. Able to read and understand all die drawings and piece part prints. Able to work on the production floor with little or no assistance. Assist CI Technicians in the CI department. Build CI dies and small progressive dies with little or no direction. Build replacement parts for CI and progressive dies from prints or existing parts. Proficiently work with precision measuring equipment. Apply thorough knowledge of manufacturing processes. Exhibit basic knowledge of capabilities: Wire EDM, CNC, and Jig Grinding, and what they will do to enhance project flow. Set up punch press, assist Press Operators on the press floor. Good center, flat, and form grinding skills. Run all Tool Room equipment: Mill, Drill, Lathe, Grinders, etc. Able to do heat treatment of die details. Good mechanical aptitude. Build and maintain tools and dies from blueprints, sketches, or oral instruction. Proficiently work with precision measuring equipment. Adapt to ever-changing priorities and production requirements.

  • Twin Falls, Idaho
  • Full time
  • $24.00 - $26.00 / HOUR
  • 40+ hours
  • 1 - 3 years experience
  • H.S. Diploma/HSE/GED
Apply

Must be at least 18 years old.
High school diploma/GED or equivalent combination of education and experience.
4-year Tool & Die Maker apprenticeship and Journeyman card preferred.
Ability to read, write and speak the English language with comprehension skills sufficient to
understand safety standards and job performance expectations.
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers,
common fractions, and decimals.
Ability to interpret instructions which may be provided in written, oral, diagram or schedule
formats.
While performing the duties of this job, the employee is regularly required to stand; and is
frequently required to walk and stop, kneel, crouch and reach. Some sitting is required. The
employee is frequently required to lift and/or move 10 pounds and occasionally lift and/or
move up to 50 pounds. Specific vision abilities required by this job include close vision,
depth perception and the ability to adjust focus.
While performing the duties of this job the employee is regularly subject to hazards, such as
proximity to moving mechanical parts, where there is air and/or skin exposure to oils and
noise.
The noise level in the environment is loud.